P0B3A — Motor electronics coolant pump B control circuit high
| Meaning | The control unit reads too high a signal on the control circuit of coolant pump B for the motor electronics. This usually points to a broken wire or contact with a power supply. Which pump is B depends on the manufacturer. The pump may not run as commanded. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power
High temperature warning
Pump not heard running
System shutting down under load or in heat
Common causes
Wire touching a power supply
Faulty pump
Fuse or relay in the supply
Fault in the control unit driver
What to do
How to read code P0B3A
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0B3A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (3A) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0B3A mean?
Motor electronics coolant pump B control circuit high. The control unit reads too high a signal on the control circuit of coolant pump B for the motor electronics. This usually points to a broken wire or contact with a power supply. Which pump is B depends on the manufacturer. The pump may not run as commanded.
Can I keep driving with code P0B3A active?
With caution: limp mode possible, have it checked soon
Common causes — P0B3A
Broken control wire or unplugged connector Wire touching a power supply Faulty pump Fuse or relay in the supply Fault in the control unit driver
How do you fix code P0B3A?
First check the connector, wiring and supply of the pump, and whether the pump runs when it should. If a temperature warning appears, stop and let it cool. It is best not to delay, to avoid damage to the electronics.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0B39 — Motor electronics coolant pump B control circuit l...
- Next code: P0B3B — Hybrid/EV battery voltage sense A circuit fault
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high