P0B39 — Motor electronics coolant pump B control circuit low
| Meaning | The control unit reads too low a signal on the control circuit of coolant pump B for the motor electronics. This usually points to a short to ground or a damaged wire. Which pump is B depends on the manufacturer. The pump may not run and the electronics risk overheating. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power
High system temperature warning
Pump noise absent or abnormal
Car goes into protection mode
Common causes
Wet or corroded connector
Pump with shorted winding or failed
Chafed or pinched wiring
Fault in the control unit driver
What to do
How to read code P0B39
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0B39 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (39) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0B39 mean?
Motor electronics coolant pump B control circuit low. The control unit reads too low a signal on the control circuit of coolant pump B for the motor electronics. This usually points to a short to ground or a damaged wire. Which pump is B depends on the manufacturer. The pump may not run and the electronics risk overheating.
Can I keep driving with code P0B39 active?
With caution: limp mode possible, have it checked soon
Common causes — P0B39
Pump control wire touching ground Wet or corroded connector Pump with shorted winding or failed Chafed or pinched wiring Fault in the control unit driver
How do you fix code P0B39?
Have the pump wiring and connector checked, looking for chafing and moisture. If temperature warnings appear, stop and let the system cool. Do not ignore it, as heat can damage the electronics.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0B38 — Motor electronics coolant pump B control circuit o...
- Next code: P0B3A — Motor electronics coolant pump B control circuit h...
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high