Skip to content
Fault code dictionary (DTC)

P0B4C — HV battery voltage sensor D: signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit found the signal from traction battery voltage sensor D below the expected minimum. It usually means a broken wire, a short to ground, or a sensor that does not respond. The exact meaning of letter D depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV fault light on
Limited power
Charge reading missing or wrong
Charging blocked
Car hard to start

Common causes

Measuring wire broken or shorted to ground
Corroded or loose connector
Faulty sensor or monitoring board
Missing sensor reference supply
Battery management unit fault

What to do

Do not work on the high-voltage system. Have the car checked urgently by qualified personnel, as power may be limited further.

How to read code P0B4C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0B4C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (4C) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0B4C mean?

HV battery voltage sensor D: signal too low. The control unit found the signal from traction battery voltage sensor D below the expected minimum. It usually means a broken wire, a short to ground, or a sensor that does not respond. The exact meaning of letter D depends on the manufacturer.

Can I keep driving with code P0B4C active?

With caution: limp mode possible, have it checked soon

Common causes — P0B4C

Measuring wire broken or shorted to ground Corroded or loose connector Faulty sensor or monitoring board Missing sensor reference supply Battery management unit fault

How do you fix code P0B4C?

Do not work on the high-voltage system. Have the car checked urgently by qualified personnel, as power may be limited further.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes