Skip to content
Fault code dictionary (DTC)

P0B86 — HV battery voltage sensor 'P': circuit fault

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe battery management controller detected a fault in the circuit that measures the voltage of one cell group of the traction battery, labelled P. The general code does not say whether the signal is low, high or erratic. Which cell group the letter P refers to is decided by the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV system warning light on
Reduced power or limp mode
Odd state-of-charge display
Combustion engine working more than usual
Hard or impossible drive-ready start

Common causes

Corroded or loose connector on the sensing harness
Damaged sensing wire
Voltage imbalance between cells
Faulty battery management controller
Moisture in the battery pack

What to do

Do not touch the orange cables or open the battery. Have the voltage data of all cell groups and any other stored codes read with a scan tool, which helps tell a circuit fault from a battery fault. Don't wait long: the car may limit power or stop.

How to read code P0B86

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0B86 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (86) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0B86 mean?

HV battery voltage sensor 'P': circuit fault. The battery management controller detected a fault in the circuit that measures the voltage of one cell group of the traction battery, labelled P. The general code does not say whether the signal is low, high or erratic. Which cell group the letter P refers to is decided by the manufacturer.

Can I keep driving with code P0B86 active?

With caution: limp mode possible, have it checked soon

Common causes — P0B86

Corroded or loose connector on the sensing harness Damaged sensing wire Voltage imbalance between cells Faulty battery management controller Moisture in the battery pack

How do you fix code P0B86?

Do not touch the orange cables or open the battery. Have the voltage data of all cell groups and any other stored codes read with a scan tool, which helps tell a circuit fault from a battery fault. Don't wait long: the car may limit power or stop.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes