P0B97 — HV battery voltage sense circuit S: signal too low
| Meaning | The hybrid/EV battery control unit reads a voltage on sense circuit "S" that is lower than the expected minimum. The letter S identifies a monitored cell group, and which one depends on the manufacturer. The low signal can come from a broken or grounded wire, or from a cell group that is really low. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power
Inconsistent battery charge indication
Combustion engine stays on more than normal
Difficulty starting, or the system will not become ready
Common causes
Sensing wire shorted to ground
Corroded or loose connector
Very discharged or degraded cell group
Fault in the battery management unit
What to do
How to read code P0B97
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0B97 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (97) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0B97 mean?
HV battery voltage sense circuit S: signal too low. The hybrid/EV battery control unit reads a voltage on sense circuit "S" that is lower than the expected minimum. The letter S identifies a monitored cell group, and which one depends on the manufacturer. The low signal can come from a broken or grounded wire, or from a cell group that is really low.
Can I keep driving with code P0B97 active?
With caution: limp mode possible, have it checked soon
Common causes — P0B97
Broken sensing wire or poor contact Sensing wire shorted to ground Corroded or loose connector Very discharged or degraded cell group Fault in the battery management unit
How do you fix code P0B97?
Only qualified staff should work on the high-voltage system. Connectors and wiring of circuit S are checked first, then the scan tool is used to compare the reading with the other cell groups. Do not clear the code to make it go away, and if the car will not start or goes into protection mode, do not keep trying.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0B96 — HV battery voltage sense circuit S: implausible si...
- Next code: P0B98 — HV battery voltage sense circuit S: signal too hig...
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high