P0B98 — HV battery voltage sense circuit S: signal too high
| Meaning | The hybrid/EV battery control unit reads a voltage on sense circuit "S" that is higher than the expected maximum. The letter S identifies a monitored cell group, and which one depends on the manufacturer. It can be caused by wiring shorted to a power source, abnormal resistance on the return side, or a wrong reading by the unit. |
| Family | Powertrain (P) |
Typical symptoms
Limited power
Inconsistent charge indication
Hybrid system assisting less or irregularly
Possible failure of the system to start
Common causes
Poor contact or high resistance on the circuit's ground connection
Damaged or corroded connector
Internal fault in the battery management unit
Cell group with a genuinely abnormal voltage
What to do
How to read code P0B98
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0B98 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (98) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0B98 mean?
HV battery voltage sense circuit S: signal too high. The hybrid/EV battery control unit reads a voltage on sense circuit "S" that is higher than the expected maximum. The letter S identifies a monitored cell group, and which one depends on the manufacturer. It can be caused by wiring shorted to a power source, abnormal resistance on the return side, or a wrong reading by the unit.
Can I keep driving with code P0B98 active?
With caution: limp mode possible, have it checked soon
Common causes — P0B98
Sensing wire touching a power supply Poor contact or high resistance on the circuit's ground connection Damaged or corroded connector Internal fault in the battery management unit Cell group with a genuinely abnormal voltage
How do you fix code P0B98?
Do not touch or disconnect high-voltage components: qualified staff are required. The wiring and connectors of circuit S are checked and the reading is compared with the real cell voltage. Do not clear the code, and have the car checked without waiting too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0B97 — HV battery voltage sense circuit S: signal too low
- Next code: P0B99 — HV battery voltage sense circuit S: intermittent o...
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high