P0BD3 — Inverter temperature sensor C: signal too low
| Meaning | The control unit detected a lower than normal voltage on the circuit of inverter temperature sensor C. This usually happens when the signal wire shorts to ground or the sensor itself is shorted. In that case the control unit cannot know the real inverter temperature and may limit power as a precaution. |
| Family | Powertrain (P) |
Typical symptoms
Reduced or limited power when accelerating
Absurd inverter temperature shown by the diagnostic tool
Cooling fans running at full speed for no reason
Warning message on the instrument cluster
Common causes
Inverter temperature sensor internally shorted
Wet, dirty or corroded connector
Internal fault in the inverter or its control board
What to do
How to read code P0BD3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0BD3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (D3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0BD3 mean?
Inverter temperature sensor C: signal too low. The control unit detected a lower than normal voltage on the circuit of inverter temperature sensor C. This usually happens when the signal wire shorts to ground or the sensor itself is shorted. In that case the control unit cannot know the real inverter temperature and may limit power as a precaution.
Can I keep driving with code P0BD3 active?
With caution: limp mode possible, have it checked soon
Common causes — P0BD3
Sensor wiring with damaged insulation touching ground Inverter temperature sensor internally shorted Wet, dirty or corroded connector Internal fault in the inverter or its control board
How do you fix code P0BD3?
First check the sensor wiring and connector for chafing, moisture or corrosion. Then measure the sensor resistance and wire continuity with a multimeter. Since the inverter's protection may be compromised, do not put the check off and rely on a workshop qualified for high-voltage work.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0BD2 — Inverter temperature sensor C: signal out of range
- Next code: P0BD4 — Inverter temperature sensor C: signal too high
Related codes
- P0B00 — Electric transmission fluid pump: phase U current fault
- P0B01 — Electric transmission fluid pump: phase U current too low
- P0B02 — Electric transmission fluid pump: phase U current too high
- P0B03 — Electric transmission fluid pump: phase V current fault
- P0B04 — Electric transmission fluid pump: phase V current too low
- P0B05 — Electric transmission fluid pump: phase V current too high
- P0B06 — Electric transmission fluid pump: phase W current fault
- P0B07 — Electric transmission fluid pump: phase W current too low
- P0B08 — Electric transmission fluid pump: phase W current too high
- P0B09 — Electric transmission fluid pump A: motor supply circuit ope...
- P0B0A — Auxiliary transmission fluid pump A: supply voltage too low
- P0B0B — Auxiliary transmission fluid pump A: supply voltage too high