Skip to content
Fault code dictionary (DTC)

P0BD4 — Inverter temperature sensor C: signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected a higher than normal voltage on the circuit of inverter temperature sensor C. This usually points to a broken wire, a disconnected connector or an open sensor. The control unit no longer reads a valid temperature and may reduce power as a precaution.
FamilyPowertrain (P)

Typical symptoms

Hybrid or electric system warning light on
Reduced power when accelerating
Inverter temperature shown as maximum value or unavailable
Cooling fans always running
Warning message on the instrument cluster

Common causes

Loose or corroded sensor or inverter connector
Broken sensor wire or damaged terminal
Inverter temperature sensor internally open
Wiring cut or pulled during a previous repair
Internal fault in the inverter or its control board

What to do

First check that the connectors are fully seated and free of corrosion, then verify the continuity of the signal wire. An open circuit leaves the control unit with no temperature information, so have it checked soon by a workshop qualified for high-voltage systems.

How to read code P0BD4

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0BD4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (D4) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0BD4 mean?

Inverter temperature sensor C: signal too high. The control unit detected a higher than normal voltage on the circuit of inverter temperature sensor C. This usually points to a broken wire, a disconnected connector or an open sensor. The control unit no longer reads a valid temperature and may reduce power as a precaution.

Can I keep driving with code P0BD4 active?

With caution: limp mode possible, have it checked soon

Common causes — P0BD4

Loose or corroded sensor or inverter connector Broken sensor wire or damaged terminal Inverter temperature sensor internally open Wiring cut or pulled during a previous repair Internal fault in the inverter or its control board

How do you fix code P0BD4?

First check that the connectors are fully seated and free of corrosion, then verify the continuity of the signal wire. An open circuit leaves the control unit with no temperature information, so have it checked soon by a workshop qualified for high-voltage systems.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes