Skip to content
Fault code dictionary (DTC)

P0BF3 — Drive motor B phase U current sensor signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe phase U current sensor of motor B is sending the control unit a signal below the allowed minimum. This usually means an open circuit, a short to ground or a sensor that is not responding. Without a correct reading the motor is not managed well.
FamilyPowertrain (P)

Typical symptoms

Hybrid or electric system warning light on
Limited power
Car struggles to start or stops
Fault message on the dashboard
Uneven running under acceleration

Common causes

Broken wire or unplugged connector
Short to ground in the wiring
Missing or low sensor supply
Faulty phase U current sensor
Internal inverter fault
Chafed or pinched wire

What to do

First check the sensor connectors and wiring, then the supply and signal with a suitable tool. High-voltage parts are for qualified staff only. If drive is limited or the car stops, have it checked urgently.

How to read code P0BF3

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0BF3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (F3) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0BF3 mean?

Drive motor B phase U current sensor signal too low. The phase U current sensor of motor B is sending the control unit a signal below the allowed minimum. This usually means an open circuit, a short to ground or a sensor that is not responding. Without a correct reading the motor is not managed well.

Can I keep driving with code P0BF3 active?

With caution: limp mode possible, have it checked soon

Common causes — P0BF3

Broken wire or unplugged connector Short to ground in the wiring Missing or low sensor supply Faulty phase U current sensor Internal inverter fault Chafed or pinched wire

How do you fix code P0BF3?

First check the sensor connectors and wiring, then the supply and signal with a suitable tool. High-voltage parts are for qualified staff only. If drive is limited or the car stops, have it checked urgently.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes