Skip to content
Fault code dictionary (DTC)

P0BF4 — Drive motor B phase U current sensor signal too high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe phase U current sensor of motor B is sending a signal above the allowed maximum. It may be a short to voltage, a faulty sensor or a genuinely excessive current. As protection the system may reduce or stop the drive.
FamilyPowertrain (P)

Typical symptoms

Hybrid or electric system warning light on
Drive reduced or cut suddenly
Fault message on the dashboard
Noise or vibration from the electric motor
Trouble restarting

Common causes

Short to voltage in the sensor wiring
Faulty phase U current sensor
Wet or corroded connector
Internal inverter fault
Degraded motor B winding or insulation
Sensor supply problem

What to do

Have the wiring and connectors checked and the measured current compared with the other phases. Do not touch the orange cables. If drive is cut or unusual noises appear, stop safely and have the car checked urgently.

How to read code P0BF4

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0BF4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (B) points to hybrid propulsion, and the last two (F4) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0BF4 mean?

Drive motor B phase U current sensor signal too high. The phase U current sensor of motor B is sending a signal above the allowed maximum. It may be a short to voltage, a faulty sensor or a genuinely excessive current. As protection the system may reduce or stop the drive.

Can I keep driving with code P0BF4 active?

With caution: limp mode possible, have it checked soon

Common causes — P0BF4

Short to voltage in the sensor wiring Faulty phase U current sensor Wet or corroded connector Internal inverter fault Degraded motor B winding or insulation Sensor supply problem

How do you fix code P0BF4?

Have the wiring and connectors checked and the measured current compared with the other phases. Do not touch the orange cables. If drive is cut or unusual noises appear, stop safely and have the car checked urgently.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes