Skip to content
Fault code dictionary (DTC)

P0C11 — Motor A inverter phase U over temperature

Severity: Critical Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected excessive temperature in phase U of the inverter for electric motor A. The inverter has three phases (U, V, W) feeding the motor, and each one heats up when current flows. When temperature exceeds the limit, the system cuts power to protect itself.
FamilyPowertrain (P)

Typical symptoms

Hybrid or electric system warning light on
Reduced power, especially under load or uphill
Very noisy cooling fans
Switch to the combustion engine
Overheating message on the dashboard

Common causes

Inverter cooling circuit low on coolant or with air in it
Weak or stopped inverter coolant pump
Blocked radiator or air intakes
Temperature sensor reading incorrectly
Internal inverter failure

What to do

Check the inverter coolant level only when cold and only if the manual allows it. If the light stays on, reduce the load and have the cooling circuit checked by a qualified workshop. Don't ignore it: repeated overheating can damage the inverter.

How to read code P0C11

This is a critical fault: vehicle safety or integrity may be compromised, so diagnosis should not be postponed.

The code P0C11 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (11) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0C11 mean?

Motor A inverter phase U over temperature. The control unit detected excessive temperature in phase U of the inverter for electric motor A. The inverter has three phases (U, V, W) feeding the motor, and each one heats up when current flows. When temperature exceeds the limit, the system cuts power to protect itself.

Can I keep driving with code P0C11 active?

With caution: limp mode possible, have it checked soon

Common causes — P0C11

Inverter cooling circuit low on coolant or with air in it Weak or stopped inverter coolant pump Blocked radiator or air intakes Temperature sensor reading incorrectly Internal inverter failure

How do you fix code P0C11?

Check the inverter coolant level only when cold and only if the manual allows it. If the light stays on, reduce the load and have the cooling circuit checked by a qualified workshop. Don't ignore it: repeated overheating can damage the inverter.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes