P0C2E — Auxiliary transmission pump module feedback signal high
| Meaning | The feedback signal sent by the auxiliary transmission fluid pump module to the control unit has too high a voltage. It can indicate contact with a power supply, a broken wire or a faulty module. The control unit cannot verify the real state of the pump. |
| Family | Powertrain (P) |
Typical symptoms
Irregular gear engagement
Stop&Start unavailable
Possible fail-safe mode
Fault that appears and disappears
Common causes
Signal circuit open
Corroded or loose connector
Faulty pump control module
Wiring damaged near the transmission
What to do
How to read code P0C2E
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C2E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (2E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C2E mean?
Auxiliary transmission pump module feedback signal high. The feedback signal sent by the auxiliary transmission fluid pump module to the control unit has too high a voltage. It can indicate contact with a power supply, a broken wire or a faulty module. The control unit cannot verify the real state of the pump.
Can I keep driving with code P0C2E active?
With caution: limp mode possible, have it checked soon
Common causes — P0C2E
Signal wire touching a power supply Signal circuit open Corroded or loose connector Faulty pump control module Wiring damaged near the transmission
How do you fix code P0C2E?
Have the wiring and connector of the pump module checked, paying attention to chafed wires or moisture. Do not leave the fault too long, because the transmission could be limited.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C2D — Auxiliary transmission pump module feedback signal...
- Next code: P0C2F — Motor/generator control module vs engine speed sen...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open