P0C2D — Auxiliary transmission pump module feedback signal low
| Meaning | The feedback signal sent by the auxiliary transmission fluid pump module to the control unit has too low a voltage. It can come from a short to ground, a weak contact or a faulty module. The control unit cannot confirm that the pump is working properly. |
| Family | Powertrain (P) |
Typical symptoms
Irregular gear engagement after a restart
Stop&Start disabled
Transmission in fail-safe mode
Intermittent operation
Common causes
Wet, corroded connector or dirty terminals
Faulty pump control module
Poor power or ground to the module
Damaged wiring
What to do
How to read code P0C2D
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C2D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (2D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C2D mean?
Auxiliary transmission pump module feedback signal low. The feedback signal sent by the auxiliary transmission fluid pump module to the control unit has too low a voltage. It can come from a short to ground, a weak contact or a faulty module. The control unit cannot confirm that the pump is working properly.
Can I keep driving with code P0C2D active?
With caution: limp mode possible, have it checked soon
Common causes — P0C2D
Signal wire shorted to ground Wet, corroded connector or dirty terminals Faulty pump control module Poor power or ground to the module Damaged wiring
How do you fix code P0C2D?
First check the ground, power supply, connector and wiring of the pump module. A signal pulled to ground can hide a fault that gets worse, so do not delay too long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C2C — Auxiliary transmission pump module feedback signal...
- Next code: P0C2E — Auxiliary transmission pump module feedback signal...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open