P0C58 — Motor B position sensor circuit A: signal high
| Meaning | The control unit reads a signal that is too high on circuit A of the position sensor on drive motor B. This can point to a short to a power supply or a faulty sensor. The rotor position is unreliable. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power or reduced mode
Vehicle will not start or stops
Rough driving
Vibration from the motor
Common causes
Damaged connector with wires touching
Faulty position sensor
Wiring damaged by heat or chafing
Faulty inverter or control unit
What to do
How to read code P0C58
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C58 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (58) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C58 mean?
Motor B position sensor circuit A: signal high. The control unit reads a signal that is too high on circuit A of the position sensor on drive motor B. This can point to a short to a power supply or a faulty sensor. The rotor position is unreliable.
Can I keep driving with code P0C58 active?
With caution: limp mode possible, have it checked soon
Common causes — P0C58
Sensor wire shorted to a power supply Damaged connector with wires touching Faulty position sensor Wiring damaged by heat or chafing Faulty inverter or control unit
How do you fix code P0C58?
Have the sensor wiring and connector checked and the signal measured with a suitable tool. If the car loses power, avoid using it. It is best to act soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C57 — Motor B position sensor circuit A: signal low
- Next code: P0C59 — Motor B position sensor circuit A: signal erratic
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open