Skip to content
Fault code dictionary (DTC)

P0C57 — Motor B position sensor circuit A: signal low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit reads a signal that is too low on circuit A of the position sensor on drive motor B. This can point to a wire shorted to ground, a break or a faulty sensor. Without the rotor position the motor cannot be driven correctly.
FamilyPowertrain (P)

Typical symptoms

Hybrid or EV system warning light on
Loss of power or reduced mode
Vehicle will not start or stops
Jerky driving
Unusual noise from the motor

Common causes

Sensor wire shorted to ground
Connector with corroded or disconnected terminals
Faulty position sensor
Pinched or chafed wiring
Faulty inverter or control unit

What to do

Visually inspect the sensor wiring and connector and have the signal and supply measured with the right tool. Do not use the car if it loses power. Act with some urgency.

How to read code P0C57

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0C57 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (57) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0C57 mean?

Motor B position sensor circuit A: signal low. The control unit reads a signal that is too low on circuit A of the position sensor on drive motor B. This can point to a wire shorted to ground, a break or a faulty sensor. Without the rotor position the motor cannot be driven correctly.

Can I keep driving with code P0C57 active?

With caution: limp mode possible, have it checked soon

Common causes — P0C57

Sensor wire shorted to ground Connector with corroded or disconnected terminals Faulty position sensor Pinched or chafed wiring Faulty inverter or control unit

How do you fix code P0C57?

Visually inspect the sensor wiring and connector and have the signal and supply measured with the right tool. Do not use the car if it loses power. Act with some urgency.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes