P0C60 — Drive motor B position sensor circuit B: signal out of range
| Meaning | The control unit is receiving a signal from the position sensor of drive motor B, circuit B, that does not agree with how the motor is really behaving or with other data. The signal is present but not believable, so the system cannot trust the rotor position. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or weak throttle response
Vibration or unusual noise from the motor
Reduced-power mode active
Traction battery draining unusually fast
Common causes
Sensor incorrectly fitted after earlier work
Wiring or connector with abnormal resistance
Electrical interference on the signal
Problem in the inverter or control unit
What to do
How to read code P0C60
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C60 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (60) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C60 mean?
Drive motor B position sensor circuit B: signal out of range. The control unit is receiving a signal from the position sensor of drive motor B, circuit B, that does not agree with how the motor is really behaving or with other data. The signal is present but not believable, so the system cannot trust the rotor position.
Can I keep driving with code P0C60 active?
With caution: limp mode possible, have it checked soon
Common causes — P0C60
Faulty or out-of-calibration position sensor (resolver) Sensor incorrectly fitted after earlier work Wiring or connector with abnormal resistance Electrical interference on the signal Problem in the inverter or control unit
How do you fix code P0C60?
Have the sensor, its mounting and the wiring checked with the proper equipment. If you notice strong vibration or loss of power, limit use of the car. Clearing the code does not fix the problem.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C5F — Drive motor B position sensor circuit B: circuit f...
- Next code: P0C61 — Drive motor B position sensor circuit B: signal to...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open