P0C61 — Drive motor B position sensor circuit B: signal too low
| Meaning | The control unit measured a lower voltage than expected on circuit B of the position sensor for drive motor B. This usually points to a broken wire, a short to ground, or a sensor that is not responding. Without this data, motor control is compromised. |
| Family | Powertrain (P) |
Typical symptoms
Sudden loss of power
Vehicle in reduced-power mode
System shutting down while driving
Hard starting or unable to start
Common causes
Broken wire or disconnected connector
Failed position sensor (resolver)
Moisture in the connector
Faulty supply or processing in the inverter
What to do
How to read code P0C61
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C61 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (61) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C61 mean?
Drive motor B position sensor circuit B: signal too low. The control unit measured a lower voltage than expected on circuit B of the position sensor for drive motor B. This usually points to a broken wire, a short to ground, or a sensor that is not responding. Without this data, motor control is compromised.
Can I keep driving with code P0C61 active?
With caution: limp mode possible, have it checked soon
Common causes — P0C61
Sensor wire shorted to ground Broken wire or disconnected connector Failed position sensor (resolver) Moisture in the connector Faulty supply or processing in the inverter
How do you fix code P0C61?
First check the connectors and the wiring along the sensor's route, looking for pinched or chafed wires. If the car shuts down or loses power, do not use it. Do not clear the code without repairing the fault.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C60 — Drive motor B position sensor circuit B: signal ou...
- Next code: P0C62 — Drive motor B position sensor circuit B: signal to...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open