P0C62 — Drive motor B position sensor circuit B: signal too high
| Meaning | The control unit measured a higher voltage than expected on circuit B of the position sensor for drive motor B. It can come from a short to a supply line, a lost contact or a faulty sensor. The system cannot read the rotor position. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Reduced-power mode
Irregular or jerky running
Sudden shutdown or failure to start
Common causes
Damaged connector or bent pins
Faulty position sensor (resolver)
Open circuit giving a wrong reading
Fault in the inverter or control unit
What to do
How to read code P0C62
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C62 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (62) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C62 mean?
Drive motor B position sensor circuit B: signal too high. The control unit measured a higher voltage than expected on circuit B of the position sensor for drive motor B. It can come from a short to a supply line, a lost contact or a faulty sensor. The system cannot read the rotor position.
Can I keep driving with code P0C62 active?
With caution: limp mode possible, have it checked soon
Common causes — P0C62
Wire shorted to a supply line Damaged connector or bent pins Faulty position sensor (resolver) Open circuit giving a wrong reading Fault in the inverter or control unit
How do you fix code P0C62?
Have the sensor wiring and connectors checked, especially for bent pins or damaged insulation. If the car loses power or shuts down, avoid using it. Clearing the code does not remove the cause.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C61 — Drive motor B position sensor circuit B: signal to...
- Next code: P0C63 — Drive motor B position sensor circuit B: erratic s...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open