P0C68 — Generator position sensor circuit A: erratic signal
| Meaning | The control unit detected that the signal from the generator position sensor, circuit A, is irregular or drops out at times. A signal that jumps makes generator control difficult. Because it is intermittent, the fault may not be present during testing. |
| Family | Powertrain (P) |
Typical symptoms
Combustion engine sometimes hard to start
Occasional jolts or vibration
Occasional loss of power
Reduced-power mode appearing and disappearing
Common causes
Wiring chafed or partly broken
Moisture getting in
Position sensor (resolver) starting to fail
Problem in the inverter or control unit
What to do
How to read code P0C68
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C68 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (68) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C68 mean?
Generator position sensor circuit A: erratic signal. The control unit detected that the signal from the generator position sensor, circuit A, is irregular or drops out at times. A signal that jumps makes generator control difficult. Because it is intermittent, the fault may not be present during testing.
Can I keep driving with code P0C68 active?
With caution: limp mode possible, have it checked soon
Common causes — P0C68
Corroded connector or loose contact Wiring chafed or partly broken Moisture getting in Position sensor (resolver) starting to fail Problem in the inverter or control unit
How do you fix code P0C68?
Have the connectors and wiring checked, flexing them while the system is monitored, because that is how an intermittent fault is found. If shutdowns or failures to start appear, do not use the car. Do not clear the code without finding the cause.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C67 — Generator position sensor circuit A: signal too hi...
- Next code: P0C69 — Generator position sensor circuit B: circuit fault
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open