P0C69 — Generator position sensor circuit B: circuit fault
| Meaning | The control unit detected a problem in circuit B of the generator position sensor. This sensor reports the rotor position of the motor-generator, which is needed for charging and for starting the combustion engine. The code points to the circuit but does not by itself say which component has failed. |
| Family | Powertrain (P) |
Typical symptoms
Combustion engine starting poorly or not at all
Poor traction battery charging
Reduced power or reduced-power mode
Vibration or irregular running
Common causes
Faulty generator position sensor (resolver)
Moisture or corrosion in the connector
Open circuit or short
Fault in the inverter or hybrid control unit
What to do
How to read code P0C69
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C69 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (69) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C69 mean?
Generator position sensor circuit B: circuit fault. The control unit detected a problem in circuit B of the generator position sensor. This sensor reports the rotor position of the motor-generator, which is needed for charging and for starting the combustion engine. The code points to the circuit but does not by itself say which component has failed.
Can I keep driving with code P0C69 active?
With caution: limp mode possible, have it checked soon
Common causes — P0C69
Damaged connector or wiring Faulty generator position sensor (resolver) Moisture or corrosion in the connector Open circuit or short Fault in the inverter or hybrid control unit
How do you fix code P0C69?
Have the sensor wiring and connectors checked, then the sensor using the manufacturer's measurements. If the combustion engine will not start or power drops sharply, avoid using the car. Do not clear the code to make it go away.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C68 — Generator position sensor circuit A: erratic signa...
- Next code: P0C6A — Generator position sensor circuit B: signal out of...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open