P0C76 — High-voltage system discharge time too long
| Meaning | After shutdown the residual voltage in the high-voltage circuits must fall within a set time. The control unit found that the discharge was slower than expected. This means voltage stays present longer than normal, which matters for the safety of anyone working on the car. |
| Family | Powertrain (P) |
Typical symptoms
Hybrid system check message
Car not starting or starting with difficulty
Limp mode with reduced power
No symptom besides the warning light
Common causes
Voltage sensor reading incorrectly
High-voltage contactor not opening properly
Loose or corroded high-voltage connections
Fault in the control unit
What to do
How to read code P0C76
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0C76 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (76) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0C76 mean?
High-voltage system discharge time too long. After shutdown the residual voltage in the high-voltage circuits must fall within a set time. The control unit found that the discharge was slower than expected. This means voltage stays present longer than normal, which matters for the safety of anyone working on the car.
Can I keep driving with code P0C76 active?
With caution: limp mode possible, have it checked soon
Common causes — P0C76
Faulty discharge circuit or resistor in the inverter Voltage sensor reading incorrectly High-voltage contactor not opening properly Loose or corroded high-voltage connections Fault in the control unit
How do you fix code P0C76?
Have the car checked by a workshop qualified for hybrid or electric vehicles without waiting long. Until it is verified, treat the system as still live: do not touch the orange cables and do not remove covers.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0C75 — High-voltage system discharge time too short
- Next code: P0C77 — High-voltage system precharge time too short
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open