P0CC0 — Drive motor A coolant temp sensor: intermittent signal
| Meaning | The control unit saw the signal from the coolant temperature sensor of drive motor A drop out or jump at times. This is typical of a contact lost with vibration or heat, or of a sensor that only works intermittently. |
| Family | Powertrain (P) |
Typical symptoms
Occasional loss of power
Temperature gauge that jumps or drops to zero
Fault appears on rough roads or when hot
Cooling fans changing speed oddly
Common causes
Sensor wire with a partial break
Sensor that works only at times
Wiring rubbing and wearing from vibration
Fault in the inverter or motor control unit
What to do
How to read code P0CC0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0CC0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (C0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0CC0 mean?
Drive motor A coolant temp sensor: intermittent signal. The control unit saw the signal from the coolant temperature sensor of drive motor A drop out or jump at times. This is typical of a contact lost with vibration or heat, or of a sensor that only works intermittently.
Can I keep driving with code P0CC0 active?
With caution: limp mode possible, have it checked soon
Common causes — P0CC0
Connector with poor contact or oxidized terminals Sensor wire with a partial break Sensor that works only at times Wiring rubbing and wearing from vibration Fault in the inverter or motor control unit
How do you fix code P0CC0?
Intermittent faults are the hardest to find: tell the technician when the problem shows up, so they can move wiring and connectors while watching the signal. Don't ignore the code just because the light sometimes goes out. High voltage work requires qualified personnel.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0CBF — Drive motor A coolant temp sensor: signal too high
- Next code: P0CC1 — Drive motor A coolant pump: control circuit open
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open