P0CC1 — Drive motor A coolant pump: control circuit open
| Meaning | The control unit detected that the control circuit of the pump that circulates coolant through electric drive motor A is open or broken. This means the electrical signal to the pump does not arrive or does not complete the circuit. Without circulation the motor and power electronics risk overheating, so the system may reduce power. |
| Family | Powertrain (P) |
Typical symptoms
Reduced power or limp mode
Pump not heard running at start-up
Motor or inverter temperature rising more than normal
Fault message on the dashboard
Common causes
Broken or damaged control wire
Internally failed pump
Faulty pump fuse or power relay
Fault in the control unit that drives the pump
What to do
How to read code P0CC1
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0CC1 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (C1) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0CC1 mean?
Drive motor A coolant pump: control circuit open. The control unit detected that the control circuit of the pump that circulates coolant through electric drive motor A is open or broken. This means the electrical signal to the pump does not arrive or does not complete the circuit. Without circulation the motor and power electronics risk overheating, so the system may reduce power.
Can I keep driving with code P0CC1 active?
With caution: limp mode possible, have it checked soon
Common causes — P0CC1
Loose or corroded pump connector Broken or damaged control wire Internally failed pump Faulty pump fuse or power relay Fault in the control unit that drives the pump
How do you fix code P0CC1?
Have the fuses, connectors and power supply of the pump checked right away, and make sure the cooling circuit is at the correct level. With this fault it is best to avoid using the car for long or under heavy load, because the risk is overheating expensive components. High voltage work requires qualified personnel.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0CC0 — Drive motor A coolant temp sensor: intermittent si...
- Next code: P0CC2 — Drive motor coolant pump A: control circuit range/...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open