Skip to content
Fault code dictionary (DTC)

P0CCA — Charge port door: open request switch circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit reads a voltage that is too high on the charge port door open switch circuit. It can indicate a broken wire, a missing contact, a short to supply voltage, or a switch that no longer closes the circuit. The open command does not arrive reliably.
FamilyPowertrain (P)

Typical symptoms

Door does not open from the button
Charging system warning light or message
Button clicks but has no effect
Door opens only with other controls
Difficulty starting a charge

Common causes

Broken switch wire or poorly seated connector
Worn or corroded switch contacts
Short to supply voltage in the wiring
Moisture or corrosion in the connector
Faulty door control unit

What to do

Check the switch connector and try opening with an alternative control. The fault usually does not stop driving but can block charging, so it is better to have it checked soon.

How to read code P0CCA

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0CCA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (CA) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0CCA mean?

Charge port door: open request switch circuit high. The control unit reads a voltage that is too high on the charge port door open switch circuit. It can indicate a broken wire, a missing contact, a short to supply voltage, or a switch that no longer closes the circuit. The open command does not arrive reliably.

Can I keep driving with code P0CCA active?

With caution: limp mode possible, have it checked soon

Common causes — P0CCA

Broken switch wire or poorly seated connector Worn or corroded switch contacts Short to supply voltage in the wiring Moisture or corrosion in the connector Faulty door control unit

How do you fix code P0CCA?

Check the switch connector and try opening with an alternative control. The fault usually does not stop driving but can block charging, so it is better to have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes