P0CCC — Charge port door: position sensor circuit fault
| Meaning | The control unit detected a fault in the circuit of the sensor that reports the position of the charge port door, meaning whether it is open or closed. Without a reliable reading, the system does not know the door state. The code does not say whether the fault is in the sensor, the wiring or the control unit. |
| Family | Powertrain (P) |
Typical symptoms
Door that does not open or close properly
Charging that does not start or is interrupted
Charging system fault warning
Door motor working abnormally
Common causes
Corroded or loose connector
Damaged or broken wiring
Door or hinge mechanically stuck or misaligned
Faulty door control unit
What to do
How to read code P0CCC
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0CCC starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (CC) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0CCC mean?
Charge port door: position sensor circuit fault. The control unit detected a fault in the circuit of the sensor that reports the position of the charge port door, meaning whether it is open or closed. Without a reliable reading, the system does not know the door state. The code does not say whether the fault is in the sensor, the wiring or the control unit.
Can I keep driving with code P0CCC active?
With caution: limp mode possible, have it checked soon
Common causes — P0CCC
Faulty or dirty position sensor Corroded or loose connector Damaged or broken wiring Door or hinge mechanically stuck or misaligned Faulty door control unit
How do you fix code P0CCC?
Check that the door moves freely and is not obstructed by dirt or ice, then check the sensor connector. It does not stop driving but can prevent charging, so have it checked in a reasonable time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0CCB — Charge port door: open request switch circuit inte...
- Next code: P0CCD — Charge port door: position sensor circuit performa...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open