P0CCE — Charge port door: position sensor circuit low
| Meaning | The control unit reads a voltage that is too low on the charge port door position sensor circuit. It usually indicates a signal wire shorted to ground or a faulty sensor. The system loses the information on whether the door is open or closed. |
| Family | Powertrain (P) |
Typical symptoms
Door not responding to commands
Charging that does not start
Charging system warning light or message
Door movement interrupted
Common causes
Faulty position sensor
Wet or corroded connector
Chafed or pinched wiring
Faulty door control unit
What to do
How to read code P0CCE
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0CCE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (CE) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0CCE mean?
Charge port door: position sensor circuit low. The control unit reads a voltage that is too low on the charge port door position sensor circuit. It usually indicates a signal wire shorted to ground or a faulty sensor. The system loses the information on whether the door is open or closed.
Can I keep driving with code P0CCE active?
With caution: limp mode possible, have it checked soon
Common causes — P0CCE
Sensor signal wire shorted to ground Faulty position sensor Wet or corroded connector Chafed or pinched wiring Faulty door control unit
How do you fix code P0CCE?
Look for traces of water or corrosion on the sensor connector and check that the wires are intact where the door moves. It does not stop the car, but it can block charging, so have the circuit checked in a reasonable time.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0CCD — Charge port door: position sensor circuit performa...
- Next code: P0CCF — Charge port door: position sensor circuit high
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open