P0CCF — Charge port door: position sensor circuit high
| Meaning | The control unit reads a voltage that is too high on the charge port door position sensor circuit. It can indicate a broken wire, an unplugged connector, a short to supply voltage or a faulty sensor. The door position information is unusable. |
| Family | Powertrain (P) |
Typical symptoms
Door that does not open or close
Charging that does not start or is interrupted
Charging system warning light or message
Door motor stopping or repeatedly trying
Common causes
Faulty position sensor
Short to supply voltage in the wiring
Corrosion in the connector
Faulty door control unit
What to do
How to read code P0CCF
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0CCF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (CF) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0CCF mean?
Charge port door: position sensor circuit high. The control unit reads a voltage that is too high on the charge port door position sensor circuit. It can indicate a broken wire, an unplugged connector, a short to supply voltage or a faulty sensor. The door position information is unusable.
Can I keep driving with code P0CCF active?
With caution: limp mode possible, have it checked soon
Common causes — P0CCF
Broken sensor wire or poorly seated connector Faulty position sensor Short to supply voltage in the wiring Corrosion in the connector Faulty door control unit
How do you fix code P0CCF?
Check that the sensor connector is fully seated and clean and that the wires are not being pulled by the door movement. It is not a fault that stops driving, but it can prevent charging, so have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0CCE — Charge port door: position sensor circuit low
- Next code: P0CD0 — Charge port door: position sensor circuit intermit...
Related codes
- P0C00 — Drive motor A current too low
- P0C01 — Drive motor A current too high
- P0C02 — Drive motor B current fault
- P0C03 — Drive motor B current too low
- P0C04 — Drive motor B current too high
- P0C05 — Motor A phase U-V-W circuit open
- P0C06 — Motor A phase U-V-W circuit low
- P0C07 — Motor A phase U-V-W circuit high
- P0C08 — Motor B phase U-V-W circuit open
- P0C09 — Motor B phase U-V-W circuit low
- P0C0A — Motor B phase U-V-W circuit high
- P0C0B — Motor A inverter power supply circuit open