Skip to content
Fault code dictionary (DTC)

P0CF5 — Charging control pilot circuit low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected on the control pilot, the communication wire with the charging station, a voltage lower than expected. It can be a short to ground, water in the port, or a problem with the cable or station.
FamilyPowertrain (P)

Typical symptoms

Charging does not start
Charging error message
Malfunction or electrical system warning light on
Problem more frequent in rain or humidity
Charging stops after a few moments

Common causes

Water or moisture in the charge port
Control pilot wire shorted to ground
Port pins damaged or dirty
Faulty cable or station
Faulty onboard charger

What to do

Check that the charge port is dry and clean and try another cable or station. Do not charge if you see water, burn marks or deformed pins; in that case have the car checked.

How to read code P0CF5

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0CF5 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (F5) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0CF5 mean?

Charging control pilot circuit low. The control unit detected on the control pilot, the communication wire with the charging station, a voltage lower than expected. It can be a short to ground, water in the port, or a problem with the cable or station.

Can I keep driving with code P0CF5 active?

With caution: limp mode possible, have it checked soon

Common causes — P0CF5

Water or moisture in the charge port Control pilot wire shorted to ground Port pins damaged or dirty Faulty cable or station Faulty onboard charger

How do you fix code P0CF5?

Check that the charge port is dry and clean and try another cable or station. Do not charge if you see water, burn marks or deformed pins; in that case have the car checked.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes