Skip to content
Fault code dictionary (DTC)

P0CF6 — Charging control pilot circuit high

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected on the control pilot, the wire the car uses to communicate with the charger, a voltage higher than expected. It can indicate a short to supply, an abnormal contact, or a problem with the cable or station.
FamilyPowertrain (P)

Typical symptoms

Charging does not start
Charging error message
Malfunction or electrical system warning light on
Charging works only with certain cables or stations
Charging stops shortly after starting

Common causes

Control pilot wire touching a supply voltage
Charge port pins damaged or dirty
Cable or station with an abnormal signal
Damaged wiring
Faulty onboard charger or charge control unit

What to do

Try another cable and another station, and look at the charge port to rule out bent pins or dirt. If the fault stays the same everywhere, have the port and wiring checked.

How to read code P0CF6

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0CF6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (C) points to hybrid propulsion, and the last two (F6) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0CF6 mean?

Charging control pilot circuit high. The control unit detected on the control pilot, the wire the car uses to communicate with the charger, a voltage higher than expected. It can indicate a short to supply, an abnormal contact, or a problem with the cable or station.

Can I keep driving with code P0CF6 active?

With caution: limp mode possible, have it checked soon

Common causes — P0CF6

Control pilot wire touching a supply voltage Charge port pins damaged or dirty Cable or station with an abnormal signal Damaged wiring Faulty onboard charger or charge control unit

How do you fix code P0CF6?

Try another cable and another station, and look at the charge port to rule out bent pins or dirt. If the fault stays the same everywhere, have the port and wiring checked.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes