Skip to content
Fault code dictionary (DTC)

P0D3C — Charger A input current sensor: unstable signal

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that the signal from the charger's input current sensor drops in and out or jumps erratically. The fault appears intermittently, so it can disappear and come back. It usually points to a poor electrical contact rather than a completely failed part.
FamilyPowertrain (P)

Typical symptoms

Warning light that comes on and goes off
Charging that stops and restarts by itself
Charging that works sometimes and not others
Highly variable charging times
Occasional hybrid/EV system error messages

Common causes

Loose, corroded or damp connector
Wiring with a partly broken wire or one that chafes
Current sensor failing intermittently
Unstable sensor ground or supply
Internal fault in the charger module

What to do

Intermittent faults are hard to trace, so note when it happens, for example in rain, in heat or with a particular charging station. Check the accessible connectors by eye. Take the car to a workshop approved for high-voltage vehicles, as the wiring may need a wiggle test with live data.

How to read code P0D3C

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0D3C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0D3C mean?

Charger A input current sensor: unstable signal. The control unit detected that the signal from the charger's input current sensor drops in and out or jumps erratically. The fault appears intermittently, so it can disappear and come back. It usually points to a poor electrical contact rather than a completely failed part.

Can I keep driving with code P0D3C active?

With caution: limp mode possible, have it checked soon

Common causes — P0D3C

Loose, corroded or damp connector Wiring with a partly broken wire or one that chafes Current sensor failing intermittently Unstable sensor ground or supply Internal fault in the charger module

How do you fix code P0D3C?

Intermittent faults are hard to trace, so note when it happens, for example in rain, in heat or with a particular charging station. Check the accessible connectors by eye. Take the car to a workshop approved for high-voltage vehicles, as the wiring may need a wiggle test with live data.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes