Skip to content
Fault code dictionary (DTC)

P0D78 — A/C compressor driver temperature sensor signal too low

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe A/C compressor control module is receiving a lower than normal voltage from the temperature sensor on its own power stage. It can come from a short to ground in the circuit, a faulty sensor, or an internal problem in the module. Since it cannot trust the reading, the module usually protects the compressor by limiting its operation. The exact sensor location depends on the manufacturer.
FamilyPowertrain (P)

Typical symptoms

Air conditioning that cools poorly or not at all
A/C compressor not engaging
Warning light on
Irregular air conditioning operation
A/C error message on some models

Common causes

Sensor wire shorted to ground
Faulty temperature sensor
Damaged or moist connector
Internal fault in the compressor control module
Pinched wiring or worn insulation
Water ingress into the module

What to do

Check the module wiring and connector for moisture, pinching or worn insulation. Then have the sensor tested with a diagnostic tool. Driving is safe, but the air conditioning will stay limited.

How to read code P0D78

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0D78 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0D78 mean?

A/C compressor driver temperature sensor signal too low. The A/C compressor control module is receiving a lower than normal voltage from the temperature sensor on its own power stage. It can come from a short to ground in the circuit, a faulty sensor, or an internal problem in the module. Since it cannot trust the reading, the module usually protects the compressor by limiting its operation. The exact sensor location depends on the manufacturer.

Can I keep driving with code P0D78 active?

With caution: limp mode possible, have it checked soon

Common causes — P0D78

Sensor wire shorted to ground Faulty temperature sensor Damaged or moist connector Internal fault in the compressor control module Pinched wiring or worn insulation Water ingress into the module

How do you fix code P0D78?

Check the module wiring and connector for moisture, pinching or worn insulation. Then have the sensor tested with a diagnostic tool. Driving is safe, but the air conditioning will stay limited.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes