Skip to content
Fault code dictionary (DTC)

P0D8A — Charge port status indicator circuit B low voltage

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe charger control unit detected a voltage that is too low in circuit B, which drives the status indicator on the charge port. In plain terms, the light that shows the charging state is not getting its signal as it should. Which wire is called circuit B depends on the manufacturer, so the wiring diagram for your car is needed.
FamilyPowertrain (P)

Typical symptoms

The light near the charge port stays off or behaves oddly
The indicator color or blinking does not match the real charging state
A charging system fault message on the dashboard
Charging that does not start or stops partway
Powertrain warning light on

Common causes

Indicator wire shorted to ground or damaged
Charge port connector corroded or wet inside
Faulty indicator light in the port
Fault in the charger module that drives the indicator
Wiring pinched or chafed on its way to the port

What to do

Look at the charge port and its connector for moisture, dirt, corrosion or damaged plastic. If charging still works you can keep driving, but have the circuit checked soon, since an electrical problem near the port should not be left to get worse.

How to read code P0D8A

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0D8A starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0D8A mean?

Charge port status indicator circuit B low voltage. The charger control unit detected a voltage that is too low in circuit B, which drives the status indicator on the charge port. In plain terms, the light that shows the charging state is not getting its signal as it should. Which wire is called circuit B depends on the manufacturer, so the wiring diagram for your car is needed.

Can I keep driving with code P0D8A active?

With caution: limp mode possible, have it checked soon

Common causes — P0D8A

Indicator wire shorted to ground or damaged Charge port connector corroded or wet inside Faulty indicator light in the port Fault in the charger module that drives the indicator Wiring pinched or chafed on its way to the port

How do you fix code P0D8A?

Look at the charge port and its connector for moisture, dirt, corrosion or damaged plastic. If charging still works you can keep driving, but have the circuit checked soon, since an electrical problem near the port should not be left to get worse.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes