P0D92 — Charge port lock control circuit low voltage
| Meaning | The control unit detected a voltage that is too low in the circuit that controls the charge connector lock. The signal to the actuator is weaker than expected, for example because of a short to ground. |
| Family | Powertrain (P) |
Typical symptoms
Charging does not start or stops
An error message at the port
Plug hard to remove
Powertrain warning light on
Common causes
Moisture in the actuator connector
Faulty lock actuator
Wiring pinched or chafed
Fault in the control module
What to do
How to read code P0D92
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D92 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D92 mean?
Charge port lock control circuit low voltage. The control unit detected a voltage that is too low in the circuit that controls the charge connector lock. The signal to the actuator is weaker than expected, for example because of a short to ground.
Can I keep driving with code P0D92 active?
With caution: limp mode possible, have it checked soon
Common causes — P0D92
Control wire shorted to ground Moisture in the actuator connector Faulty lock actuator Wiring pinched or chafed Fault in the control module
How do you fix code P0D92?
Check the port and connector for water or dirt. Have the circuit checked soon, and do not force the plug if it is stuck.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D91 — Charge port lock control circuit open
- Next code: P0D93 — Charge port lock control circuit high voltage
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range