P0D96 — Charge port unlock control circuit low voltage
| Meaning | The control unit detected a voltage that is too low in the circuit that commands unlocking of the charge connector. The signal to the actuator is weaker than expected, for example because of a short to ground. |
| Family | Powertrain (P) |
Typical symptoms
Slow or absent unlocking
An error message at the port
Charging does not start
Powertrain warning light on
Common causes
Moisture in the actuator connector
Faulty unlock actuator
Wiring pinched or chafed
Fault in the control module
What to do
How to read code P0D96
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P0D96 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P0D96 mean?
Charge port unlock control circuit low voltage. The control unit detected a voltage that is too low in the circuit that commands unlocking of the charge connector. The signal to the actuator is weaker than expected, for example because of a short to ground.
Can I keep driving with code P0D96 active?
With caution: limp mode possible, have it checked soon
Common causes — P0D96
Control wire shorted to ground Moisture in the actuator connector Faulty unlock actuator Wiring pinched or chafed Fault in the control module
How do you fix code P0D96?
Do not force the plug if it stays locked, and check the owner's manual for the emergency release. Have the circuit checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P0D95 — Charge port unlock control circuit open
- Next code: P0D97 — Charge port unlock control circuit high voltage
Related codes
- P0D00 — Control Pilot ventilation switch circuit open
- P0D01 — Control Pilot ventilation switch signal out of range
- P0D02 — Control Pilot ventilation switch circuit low
- P0D03 — Control Pilot ventilation switch circuit high
- P0D04 — Control Pilot ventilation switch intermittent or erratic
- P0D05 — Control Pilot ventilation switch stuck off
- P0D06 — Control Pilot ventilation switch stuck on
- P0D07 — Charging system positive contactor A circuit fault
- P0D08 — Charging positive contactor A stuck closed
- P0D09 — Charging positive contactor A stuck open
- P0D0A — Charging positive contactor A control circuit open
- P0D0B — Charging positive contactor A control circuit out of range