Skip to content
Fault code dictionary (DTC)

P0012 — Camshaft A timing over-retarded, bank 1

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected that camshaft A on bank 1, usually the intake one, is more retarded than expected relative to the crankshaft. The timing isn't moving to the requested position.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Rough idle or stalling
Loss of power
Hard starting
Noise from the timing area

Common causes

Dirty, low or unsuitable oil
Faulty or stuck timing solenoid
Worn camshaft phaser
Stretched timing chain or belt, or one that has jumped a tooth
Low oil pressure

What to do

Check the oil level and condition right away. If you hear noise from the timing area, stop and have it checked, because incorrect timing can damage the engine.

How to read code P0012

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P0012 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (12) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0012 mean?

Camshaft A timing over-retarded, bank 1. The control unit detected that camshaft A on bank 1, usually the intake one, is more retarded than expected relative to the crankshaft. The timing isn't moving to the requested position.

Can I keep driving with code P0012 active?

With caution: limp mode possible, have it checked soon

Common causes — P0012

Dirty, low or unsuitable oil Faulty or stuck timing solenoid Worn camshaft phaser Stretched timing chain or belt, or one that has jumped a tooth Low oil pressure

How do you fix code P0012?

Check the oil level and condition right away. If you hear noise from the timing area, stop and have it checked, because incorrect timing can damage the engine.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes