P001C — Camshaft profile actuator A control circuit high, bank 1
| Meaning | The engine computer sees a signal that is too high in the control circuit of the camshaft profile actuator on bank 1. This usually points to a short to power in the wiring or a fault in the actuator. The exact name of the system depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Rough idle
Engine feels dull
Possible limp mode
Common causes
Faulty actuator or solenoid
Damaged or corroded connector
Wiring damaged by heat
Faulty engine computer (rare)
What to do
How to read code P001C
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P001C starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (1C) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P001C mean?
Camshaft profile actuator A control circuit high, bank 1. The engine computer sees a signal that is too high in the control circuit of the camshaft profile actuator on bank 1. This usually points to a short to power in the wiring or a fault in the actuator. The exact name of the system depends on the manufacturer.
Can I keep driving with code P001C active?
With caution: limp mode possible, have it checked soon
Common causes — P001C
Short to power in the wiring Faulty actuator or solenoid Damaged or corroded connector Wiring damaged by heat Faulty engine computer (rare)
How do you fix code P001C?
Inspect the actuator wiring and connector and have the circuit measured at a workshop. Do not leave it too long, because an electrical fault can get worse.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P001B — Camshaft profile actuator A control circuit low, b...
- Next code: P001D — Camshaft profile actuator A control circuit open,...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2