P001D — Camshaft profile actuator A control circuit open, bank 2
| Meaning | The engine computer detected an open circuit, meaning a break, in the control of the actuator that changes the camshaft profile on bank 2. The exact name of the system depends on the manufacturer. The electrical command is not reaching the actuator. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Rough idle
Engine less lively at high revs
Possible limp mode
Common causes
Faulty actuator or solenoid
Corroded connector terminals
Wiring damaged by heat or rubbing
Faulty engine computer (rare)
What to do
How to read code P001D
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P001D starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (1D) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P001D mean?
Camshaft profile actuator A control circuit open, bank 2. The engine computer detected an open circuit, meaning a break, in the control of the actuator that changes the camshaft profile on bank 2. The exact name of the system depends on the manufacturer. The electrical command is not reaching the actuator.
Can I keep driving with code P001D active?
With caution: limp mode possible, have it checked soon
Common causes — P001D
Broken wire or unplugged connector Faulty actuator or solenoid Corroded connector terminals Wiring damaged by heat or rubbing Faulty engine computer (rare)
How do you fix code P001D?
Check the connector and wiring of the bank 2 actuator. The engine may still run, but have it checked soon so the fault does not get worse.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P001C — Camshaft profile actuator A control circuit high,...
- Next code: P001E — Camshaft profile actuator A control circuit low, b...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2