P001E — Camshaft profile actuator A control circuit low, bank 2
| Meaning | The engine computer sees a signal that is too low in the control circuit of the camshaft profile actuator on bank 2. This usually points to a short to ground in the wiring or in the actuator itself. The exact name of the system depends on the manufacturer. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Unstable idle
Poor throttle response
Possible limp mode
Common causes
Faulty actuator or solenoid
Connector with water or corrosion
Wire rubbed against the engine
Faulty engine computer (rare)
What to do
How to read code P001E
This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.
The code P001E starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (1E) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P001E mean?
Camshaft profile actuator A control circuit low, bank 2. The engine computer sees a signal that is too low in the control circuit of the camshaft profile actuator on bank 2. This usually points to a short to ground in the wiring or in the actuator itself. The exact name of the system depends on the manufacturer.
Can I keep driving with code P001E active?
With caution: limp mode possible, have it checked soon
Common causes — P001E
Short to ground in the wiring Faulty actuator or solenoid Connector with water or corrosion Wire rubbed against the engine Faulty engine computer (rare)
How do you fix code P001E?
Check the bank 2 actuator wiring and connector, looking for worn insulation. Have it checked soon: a short can also damage the engine computer.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P001D — Camshaft profile actuator A control circuit open,...
- Next code: P001F — Camshaft profile actuator A control circuit high,...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2