Skip to content
Fault code dictionary (DTC)

P0074 — Ambient air temperature sensor circuit intermittent

Severity: Informational Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer detected that the signal from the outside temperature sensor comes and goes or jumps suddenly. This usually points to an unstable contact rather than a sensor that is permanently dead.
FamilyPowertrain (P)

Typical symptoms

Outside temperature that appears, disappears or jumps
Inconsistent automatic climate control
Check engine light on at times
No other obvious symptoms

Common causes

Connector with unstable contact
Partly broken or chafed wire
Moisture or corrosion in the connector
Faulty sensor
Computer problem, uncommon

What to do

Gently move the sensor wiring and connector while watching whether the reading changes, or have a workshop do it. It isn't urgent, but intermittent faults tend to get worse.

How to read code P0074

This is an informational entry: it normally does not limit how the vehicle works.

The code P0074 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (74) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P0074 mean?

Ambient air temperature sensor circuit intermittent. The engine computer detected that the signal from the outside temperature sensor comes and goes or jumps suddenly. This usually points to an unstable contact rather than a sensor that is permanently dead.

Can I keep driving with code P0074 active?

With caution: limp mode possible, have it checked soon

Common causes — P0074

Connector with unstable contact Partly broken or chafed wire Moisture or corrosion in the connector Faulty sensor Computer problem, uncommon

How do you fix code P0074?

Gently move the sensor wiring and connector while watching whether the reading changes, or have a workshop do it. It isn't urgent, but intermittent faults tend to get worse.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes