Skip to content
Fault code dictionary (DTC)

P00A3 — Charge air cooler temperature sensor signal too high, bank 2

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe engine computer is receiving a higher voltage than possible from the air temperature sensor after the intercooler on bank 2. Usually the circuit is open, the connector is unplugged or the sensor is faulty. The computer then reads a very low temperature that is not real.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Loss of power
Unstable idle
Dark smoke from the exhaust on some engines
Limp mode with reduced power

Common causes

Sensor connector unplugged or with corroded terminals
Broken signal or ground wire
Temperature sensor with a broken internal element
Stretched or cut wiring
Faulty computer input, which is rare

What to do

First check that the connector is fully seated and clean, then follow the wiring looking for stretched or broken wires. A scan tool shows whether the value is stuck at the minimum. If power is limited, drive carefully and have it checked soon.

How to read code P00A3

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P00A3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (A3) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00A3 mean?

Charge air cooler temperature sensor signal too high, bank 2. The engine computer is receiving a higher voltage than possible from the air temperature sensor after the intercooler on bank 2. Usually the circuit is open, the connector is unplugged or the sensor is faulty. The computer then reads a very low temperature that is not real.

Can I keep driving with code P00A3 active?

With caution: limp mode possible, have it checked soon

Common causes — P00A3

Sensor connector unplugged or with corroded terminals Broken signal or ground wire Temperature sensor with a broken internal element Stretched or cut wiring Faulty computer input, which is rare

How do you fix code P00A3?

First check that the connector is fully seated and clean, then follow the wiring looking for stretched or broken wires. A scan tool shows whether the value is stuck at the minimum. If power is limited, drive carefully and have it checked soon.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes