P00A2 — Charge air cooler temperature sensor signal too low, bank 2
| Meaning | The engine computer is receiving a lower voltage than possible from the air temperature sensor after the intercooler on bank 2. Usually the signal wire is shorted to ground or the sensor is internally shorted. The computer then reads a very high temperature that is not real. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power
Reduced boost pressure
Uneven idle
Limp mode with reduced power
Common causes
Temperature sensor internally shorted
Water or corrosion in the connector
Pinched wiring or worn insulation
Faulty computer input, which is rare
What to do
How to read code P00A2
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00A2 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (A2) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00A2 mean?
Charge air cooler temperature sensor signal too low, bank 2. The engine computer is receiving a lower voltage than possible from the air temperature sensor after the intercooler on bank 2. Usually the signal wire is shorted to ground or the sensor is internally shorted. The computer then reads a very high temperature that is not real.
Can I keep driving with code P00A2 active?
With caution: limp mode possible, have it checked soon
Common causes — P00A2
Signal wire touching ground Temperature sensor internally shorted Water or corrosion in the connector Pinched wiring or worn insulation Faulty computer input, which is rare
How do you fix code P00A2?
Unplug the connector and check for water, corrosion or bent terminals, then inspect the wiring. A scan tool verifies the value being read. If power is limited, drive carefully and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00A1 — Charge air cooler temperature sensor reading not p...
- Next code: P00A3 — Charge air cooler temperature sensor signal too hi...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2