Skip to content
Fault code dictionary (DTC)

P00AA — Intake air temperature sensor 1 circuit fault (bank 2)

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit detected a problem in the electrical circuit of the first intake air temperature sensor on bank 2. This is a generic code: it says the signal is not correct, but not whether it is too high, too low or unstable. The other codes or a direct measurement are needed to understand it better.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Rough idle
Less responsive cold starts
Reduced performance
Slightly higher fuel consumption

Common causes

Damaged or corroded sensor connector
Broken or shorted wiring
Faulty temperature sensor
Supply or ground problem at the sensor
Engine control unit fault (rare)

What to do

Visually check the sensor, connector and wires on bank 2. You can usually keep driving, but have the sensor data read soon, because the control unit may be using fallback values.

How to read code P00AA

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P00AA starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (AA) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00AA mean?

Intake air temperature sensor 1 circuit fault (bank 2). The control unit detected a problem in the electrical circuit of the first intake air temperature sensor on bank 2. This is a generic code: it says the signal is not correct, but not whether it is too high, too low or unstable. The other codes or a direct measurement are needed to understand it better.

Can I keep driving with code P00AA active?

With caution: limp mode possible, have it checked soon

Common causes — P00AA

Damaged or corroded sensor connector Broken or shorted wiring Faulty temperature sensor Supply or ground problem at the sensor Engine control unit fault (rare)

How do you fix code P00AA?

Visually check the sensor, connector and wires on bank 2. You can usually keep driving, but have the sensor data read soon, because the control unit may be using fallback values.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes