P00AB — Intake air temperature sensor 1 reading implausible (bank 2)
| Meaning | The control unit is receiving from the first intake air temperature sensor on bank 2 a value that does not match the other engine conditions. The sensor may show a frozen temperature or one different from the real one. The electrical circuit may be fine: the doubt is about the accuracy of the reading. |
| Family | Powertrain (P) |
Typical symptoms
Reduced performance
Uneven idle
Hard cold starts
Fuel consumption slightly off
Common causes
Faulty sensor
Air leaks in the intake duct near the sensor
Connector with poor contact
Sensor badly fitted or outside the airflow
Problem with hoses or the intercooler
What to do
How to read code P00AB
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00AB starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (AB) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00AB mean?
Intake air temperature sensor 1 reading implausible (bank 2). The control unit is receiving from the first intake air temperature sensor on bank 2 a value that does not match the other engine conditions. The sensor may show a frozen temperature or one different from the real one. The electrical circuit may be fine: the doubt is about the accuracy of the reading.
Can I keep driving with code P00AB active?
With caution: limp mode possible, have it checked soon
Common causes — P00AB
Dirty or aged sensor reading inaccurately Faulty sensor Air leaks in the intake duct near the sensor Connector with poor contact Sensor badly fitted or outside the airflow Problem with hoses or the intercooler
How do you fix code P00AB?
First check the sensor, how it is fitted and the nearby intake hoses, looking for cracks or loose clamps. You can use the car with care, but do not put the check off for long.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00AA — Intake air temperature sensor 1 circuit fault (ban...
- Next code: P00AC — Intake air temperature sensor 1 signal low (bank 2...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2