P00B4 — Radiator coolant temperature sensor signal high
| Meaning | The control unit detected that the signal from the coolant temperature sensor at the radiator outlet is above the expected limit. The voltage is too high, as if the coolant were freezing or as if the circuit were open. It usually points to a detached wire, an open connector or a faulty sensor. |
| Family | Powertrain (P) |
Typical symptoms
Fans not starting or starting late
Temperature gauge stuck or abnormal
Hard cold starts
Risk of overheating without a clear warning
Common causes
Broken signal or ground wire
Faulty sensor with an open circuit
Corrosion in the connector
Cut or torn wiring
Engine control unit fault (rare)
What to do
How to read code P00B4
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00B4 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (B4) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00B4 mean?
Radiator coolant temperature sensor signal high. The control unit detected that the signal from the coolant temperature sensor at the radiator outlet is above the expected limit. The voltage is too high, as if the coolant were freezing or as if the circuit were open. It usually points to a detached wire, an open connector or a faulty sensor.
Can I keep driving with code P00B4 active?
With caution: limp mode possible, have it checked soon
Common causes — P00B4
Unplugged connector or pins pushed out Broken signal or ground wire Faulty sensor with an open circuit Corrosion in the connector Cut or torn wiring Engine control unit fault (rare)
How do you fix code P00B4?
First check that the connector is fully seated and that the wires are intact. If the fans do not start, the engine can overheat: watch the gauge and the coolant level, and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00B3 — Radiator coolant temperature sensor signal low
- Next code: P00B5 — Radiator coolant temperature sensor signal erratic
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2