P00B3 — Radiator coolant temperature sensor signal low
| Meaning | The control unit detected that the signal from the coolant temperature sensor at the radiator outlet is below the expected limit. The voltage is too low, as if the coolant were very hot or as if the wire were shorted to ground. It is usually an electrical problem in the circuit or in the sensor. |
| Family | Powertrain (P) |
Typical symptoms
Cooling fans running constantly
Temperature gauge showing abnormal values
Hard hot starts
Higher than normal fuel consumption
Common causes
Wet or damaged connector
Faulty sensor with an internal short
Crushed or chafed wiring
Engine control unit fault (rare)
What to do
How to read code P00B3
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00B3 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (B3) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00B3 mean?
Radiator coolant temperature sensor signal low. The control unit detected that the signal from the coolant temperature sensor at the radiator outlet is below the expected limit. The voltage is too low, as if the coolant were very hot or as if the wire were shorted to ground. It is usually an electrical problem in the circuit or in the sensor.
Can I keep driving with code P00B3 active?
With caution: limp mode possible, have it checked soon
Common causes — P00B3
Signal wire shorted to ground Wet or damaged connector Faulty sensor with an internal short Crushed or chafed wiring Engine control unit fault (rare)
How do you fix code P00B3?
First check the sensor connector and wiring, looking for chafed wires or moisture. Do not trust the temperature gauge until this is clarified: check the coolant level and have it checked soon.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00B2 — Radiator coolant temperature sensor reading implau...
- Next code: P00B4 — Radiator coolant temperature sensor signal high
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2