P00B8 — Pressure and air flow mismatch, bank 2
| Meaning | The control unit compared the intake manifold pressure reading (MAP) with the air flow measured by the air flow sensor on bank 2, and the two values do not agree. Either one sensor is reading incorrectly, or the air is not travelling the path the engine expects, for example because of an air leak. |
| Family | Powertrain (P) |
Typical symptoms
Sluggish acceleration
Rough idle
Higher fuel consumption than usual
Possible limp mode with reduced power
Common causes
Dirty or faulty air flow sensor
Intake leak or loose intake hose
Cracked or disconnected vacuum line to the sensor
Damaged wiring or connector on either sensor
Heavily clogged air filter
What to do
How to read code P00B8
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00B8 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (B8) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00B8 mean?
Pressure and air flow mismatch, bank 2. The control unit compared the intake manifold pressure reading (MAP) with the air flow measured by the air flow sensor on bank 2, and the two values do not agree. Either one sensor is reading incorrectly, or the air is not travelling the path the engine expects, for example because of an air leak.
Can I keep driving with code P00B8 active?
With caution: limp mode possible, have it checked soon
Common causes — P00B8
Dirty or out-of-calibration MAP sensor Dirty or faulty air flow sensor Intake leak or loose intake hose Cracked or disconnected vacuum line to the sensor Damaged wiring or connector on either sensor Heavily clogged air filter
How do you fix code P00B8?
First check the intake hoses, clamps and the connectors of both sensors for leaks and corroded contacts. The car can be driven for short trips, but don't leave it for long: a wrong air-fuel mixture strains the engine and the catalytic converter.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00B7 — Engine coolant flow low or not as expected
- Next code: P00B9 — Low fuel pressure at low ambient temperature
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2