Skip to content
Fault code dictionary (DTC)

P00C6 — Fuel rail pressure too low during cranking, bank 1

Severity: Serious Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningWhile the engine is turning on the starter, pressure in the fuel rail on bank 1 does not reach the required value. Without the right pressure, starting can be slow or fail altogether.
FamilyPowertrain (P)

Typical symptoms

Engine cranks but doesn't start
Very long starting time
Check engine light on
Starts only after several attempts
Stalls right after starting

Common causes

Weak feed pump
Clogged fuel filter
Worn high-pressure pump
Injector or circuit leaks
Faulty rail pressure sensor
Almost empty tank or unsuitable fuel

What to do

First check the fuel level, then have the filter and pumps checked. Avoid cranking for long periods, to avoid draining the battery and stressing the system.

How to read code P00C6

This is a serious fault: driving behaviour may get worse or other components may be damaged if the vehicle is used without checking it.

The code P00C6 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (C6) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00C6 mean?

Fuel rail pressure too low during cranking, bank 1. While the engine is turning on the starter, pressure in the fuel rail on bank 1 does not reach the required value. Without the right pressure, starting can be slow or fail altogether.

Can I keep driving with code P00C6 active?

With caution: limp mode possible, have it checked soon

Common causes — P00C6

Weak feed pump Clogged fuel filter Worn high-pressure pump Injector or circuit leaks Faulty rail pressure sensor Almost empty tank or unsuitable fuel

How do you fix code P00C6?

First check the fuel level, then have the filter and pumps checked. Avoid cranking for long periods, to avoid draining the battery and stressing the system.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes