Skip to content
Fault code dictionary (DTC)

P00CE — Intake air temperature sensors disagree, bank 1

Severity: Warning Can you drive? With caution: limp mode possible, have it checked soon Make: All makes (OBD-II standard)
MeaningThe control unit compares the readings of several intake air temperature sensors on bank 1 and found values that do not match as they should. It does not say which sensor is wrong, only that the readings are not consistent with each other. A wrong air temperature skews the calculation of fuel quantity and boost pressure.
FamilyPowertrain (P)

Typical symptoms

Check engine light on
Slight loss of performance
Higher fuel consumption than usual
Unsteady idle or uncertain throttle response
Possible power limitation on turbo engines

Common causes

A dirty or out-of-range intake air temperature sensor
Corroded or damaged connector or wiring on one of the sensors
Sensor failed internally
Leaks or air intrusion in the intake duct altering the reading
Control unit problem (rare)

What to do

First check the connectors and wiring of the temperature sensors in the intake duct, and make sure they are clean and undamaged. The car can usually be driven, but get it checked soon to avoid incorrect fuelling.

How to read code P00CE

This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.

The code P00CE starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (CE) identify the specific fault inside that group.

How to proceed, in order

  1. Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
  2. Check connectors, wiring and grounds of the component involved, and the battery voltage.
  3. Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
  4. After the repair, clear the code and confirm with a road test that it does not come back.

Frequently asked questions

What does code P00CE mean?

Intake air temperature sensors disagree, bank 1. The control unit compares the readings of several intake air temperature sensors on bank 1 and found values that do not match as they should. It does not say which sensor is wrong, only that the readings are not consistent with each other. A wrong air temperature skews the calculation of fuel quantity and boost pressure.

Can I keep driving with code P00CE active?

With caution: limp mode possible, have it checked soon

Common causes — P00CE

A dirty or out-of-range intake air temperature sensor Corroded or damaged connector or wiring on one of the sensors Sensor failed internally Leaks or air intrusion in the intake duct altering the reading Control unit problem (rare)

How do you fix code P00CE?

First check the connectors and wiring of the temperature sensors in the intake duct, and make sure they are clean and undamaged. The car can usually be driven, but get it checked soon to avoid incorrect fuelling.

Need help with this fault?

We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.

Write to us on WhatsApp Contact us
Where to get it fixed

Related codes