P00CF — Barometric and turbo boost pressure sensor A disagree
| Meaning | The control unit compares atmospheric pressure with the reading from the turbo boost pressure sensor (sensor A) at engine off or minimal load, and found that the two values do not match. One of the two sensors is giving a wrong reading, or there is a circuit problem. With wrong data, boost control can become inaccurate. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power, especially when accelerating
Turbo pushing weakly or unevenly
Limp mode with limited power
Higher fuel consumption
Common causes
Failed or out-of-range barometric sensor
Corroded or damaged connector or wiring
Blocked or cracked sensor hose
Control unit problem (rare)
What to do
How to read code P00CF
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00CF starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (CF) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00CF mean?
Barometric and turbo boost pressure sensor A disagree. The control unit compares atmospheric pressure with the reading from the turbo boost pressure sensor (sensor A) at engine off or minimal load, and found that the two values do not match. One of the two sensors is giving a wrong reading, or there is a circuit problem. With wrong data, boost control can become inaccurate.
Can I keep driving with code P00CF active?
With caution: limp mode possible, have it checked soon
Common causes — P00CF
Dirty or failed turbo pressure sensor A Failed or out-of-range barometric sensor Corroded or damaged connector or wiring Blocked or cracked sensor hose Control unit problem (rare)
How do you fix code P00CF?
Check the small hose and connector of the boost pressure sensor and make sure there are no cracks or blockages. If power drops a lot or the car goes into protection mode, avoid heavy loads and have the sensors checked.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00CE — Intake air temperature sensors disagree, bank 1
- Next code: P00D0 — Barometric and turbo boost pressure sensor B disag...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2