P00D0 — Barometric and turbo boost pressure sensor B disagree
| Meaning | The control unit compares atmospheric pressure with the reading from turbo boost pressure sensor B and found values that do not match. Either one of the two sensors or their circuit may be at fault. Sensor B is the second boost pressure sensor, fitted on engines with more sensors or more than one turbo. |
| Family | Powertrain (P) |
Typical symptoms
Loss of power when accelerating
Uneven boost
Limp mode with reduced power
Higher fuel consumption
Common causes
Failed or out-of-range barometric sensor
Corroded or damaged connector or wiring
Blocked or cracked sensor hose or pressure port
Control unit problem (rare)
What to do
How to read code P00D0
This is a warning: the vehicle usually keeps working, but the control unit may limit performance (limp mode) until the fault is removed.
The code P00D0 starts with P: it belongs to the powertrain (engine and transmission) area. It is defined by the SAE/ISO standard, so it means the same on every make. The third character (0) points to fuel and air metering and auxiliary emission controls, and the last two (D0) identify the specific fault inside that group.
How to proceed, in order
- Read the code with the diagnostic tool and note the freeze-frame data and any other stored codes.
- Check connectors, wiring and grounds of the component involved, and the battery voltage.
- Measure the real values of the component with the diagnostic tool instead of replacing it by guesswork.
- After the repair, clear the code and confirm with a road test that it does not come back.
Frequently asked questions
What does code P00D0 mean?
Barometric and turbo boost pressure sensor B disagree. The control unit compares atmospheric pressure with the reading from turbo boost pressure sensor B and found values that do not match. Either one of the two sensors or their circuit may be at fault. Sensor B is the second boost pressure sensor, fitted on engines with more sensors or more than one turbo.
Can I keep driving with code P00D0 active?
With caution: limp mode possible, have it checked soon
Common causes — P00D0
Dirty or failed turbo pressure sensor B Failed or out-of-range barometric sensor Corroded or damaged connector or wiring Blocked or cracked sensor hose or pressure port Control unit problem (rare)
How do you fix code P00D0?
Check the connector, wiring and pressure hose of sensor B and make sure they are intact and clean. If the car loses a lot of power or goes into protection mode, limit its use and have the sensors diagnosed.
We are ECU specialists: diagnosis, file repair and remapping for cars, bikes, trucks and agricultural vehicles.
Write to us on WhatsApp Contact us- Previous code: P00CF — Barometric and turbo boost pressure sensor A disag...
- Next code: P00D1 — O2 sensor heater circuit performance, bank 1 senso...
Related codes
- P0001 — Fuel Volume Regulator Control Circuit Open
- P0002 — Fuel volume regulator performance out of range
- P0003 — Fuel volume regulator control circuit low
- P0004 — Fuel volume regulator control circuit high
- P0005 — Fuel shutoff valve control circuit fault
- P0006 — Fuel shutoff valve control circuit low
- P0007 — Fuel shutoff valve control circuit high
- P0008 — Engine position system performance, bank 1
- P0009 — Engine position system performance, bank 2
- P000A — Camshaft A position slow response, bank 1
- P000B — Camshaft B position slow response, bank 1
- P000C — Camshaft A position slow response, bank 2